CART: (0) items
Mon-Fri 6:00AM - 4:00PM MST
Kent-Moore EN-49960 Injector Nozzle Sleeve Puller (EN49960)

Kent-Moore EN-49960 Injector Nozzle Sleeve Puller (EN49960)

Part Number:KMTEN-49960

Have you checked availability on this item before ordering?

Have you Checked Product Availability with Us? help


Email (Click here) to check availability before ordering
Kent-Moore Tools
Kent-Moore EN-49960 Injector Nozzle Sleeve Puller

The current service procedure to replace the injector nozzle sleeve involves removing the cylinder head. EN-49960 allows injector nozzle sleeve replacement with the head installed on the engine. EN-49960-3 Remover is seated into the nozzle sleeve, and turned counter-clockwise with a wrench to unscrew it from the cylinder head. If a sleeve spins without removal, a slide hammer with 1/2"-13 thread (such as J-23907-1) is installed into EN-49960-3, and used to remove the nozzle sleeve. Once the new sleeve is ready for installation, it is placed onto EN-49960-1 Installer Guide, and seated lightly into the head with a hammer against EN-49960-1. The Injector clamp is used to hold EN-49960-1 and the sleeve in place. EN-49960-3 Swager is guided through EN-49960-1, and seated with a hammer. The included hardware is then threaded onto to EN-49960-3 remove it from EN-49960-1

Email for product availability.

Reward Points

VIP Members earn 19 points when you buy this item. For VIP Membership info click here

Related Items

Recently Viewed Items

Browse By Category
Browse By Price
New Releases
Top Sellers