Kent-Moore EN-48266 Injector Seal Installer / Sizer
For GM / General Motors. EN-48266 is used to install the teflon seal onto the end of the injector. The pilot cone is placed onto the end of the injector, and the seal is started over the cone. The installer is used to push the seal into the groove on the injector tip, and the sizer is placed over the seal to compress it back to the correct OD to allow installation into the cylinder head. Unapproved methods will damage the seal, resulting in compression loss and oil or fuel consumption.Email
Handsontools® is your one source for auto mechanic and body shop tools, shop equipment, industrial tools and shop supplies. Specialists in vehicle specific mechanic tools, shop tools, industrial tools and shop equipment.