Kent-Moore DT-51075 Puller Legs (DT50175)
TR3160 Manual Trans
The 4th speed driven gear is pressed onto the main shaft approximately 30 cm (12 in.) from the end of the shaft, and has a high interference fit, with very little clearance under the gear. In order to remove the gear for unit repair, a puller must overcome the press load, length of pull, and limited clearance. DT-51075 puller legs fit under the gear, and are used with either J-22888-20A or J-8433-1 pullers (TBD) against the end of the shaft to pull the gear. In order to prevent slipping and causing gear damage, DT-51075 includes a collar to hold the ends of the legs engaged around the gear.Email
for product availability.
Handsontools® is your one source for auto mechanic and body shop tools, shop equipment, industrial tools and shop supplies. Specialists in vehicle specific mechanic tools, shop tools, industrial tools and shop equipment.