Kent-Moore DT-49906 Remover, Pinion Inner Bearing Cup
The inner pinion bearing cup is bottomed into its bore in the RDM housing, without access to remove it using a brass drift, as used on other axles. Because of the limited access and lack of reliefs in the casting, DT-49906 is designed to fit through the bearing cup on 218 mm ring gear RDMs, and then be seated against the exposed cup lip (approximately 1-2 mm). Once DT-49906 is positioned correctly, previously Essential J-42176 Driver Handle is attached to DT-49906 and used with a hammer to drive the cup out of the RDM housing.Email
for product availability.